You know your heater works, but do you know if it works safely? An old or improperly functioning heater can leak
monoxide into your home. Carbon monoxide is an odorless, colorless and tasteless gas that is highly toxic to humans
animals Our heater tune-up is designed to verify safe and proper operation of your system.
Your heating system is a major investment in your home and is the most taken for granted appliance/system we have.
of sight, out of mind. The magic box on the wall (thermostat) makes heat. Approximately, half of homeowners do not
their units serviced until it breaks down (‘if it’s not broke, don’t fix it’). Well, if you want a safer, longer
average system life, the most comfort and the lowest utility bill, trust ideal Air Services to keep it in like new
You wouldn’t wait until your car broke down to change the oil, right?
Protect your investment with a regular tune-up.
- Check heating performance, temperature rise & determine if adjustments are needed.
- Clean heat exchanger and inspect for combustion leaks …. Heat exchanger will be inspected for cracks &
deterioration. Heat exchangers can develop cracks with age. If they exist, there is a risk of fire or carbon
- Test for carbon monoxide …..Carbon monoxide is a dangerous odorless gas.
- Clean burners and adjust for maximum efficiency .. Dirty burners can cause poor combustion.
- Check pilot assembly and inspect thermocouple … A defective thermocouple will cause the furnace to shut down.
or dirty pilots can easily be extinguished causing the furnace to shut down.
- Inspect flame sensor
- Examine flue pipe and inspect venting system
- Verify proper inducer motor operation. … This motor exhausts the flue gases out of the vent system
- Verify proper ignition …Proper air/fuel mixture should result in a blue flame.
- Inspect gas piping and valve … Gas line will be leak checked from the furnace shut off valve to the burners
Undetected gas leaks are dangerous
- Flush condensate drain to protect against overflow … Drains will be tested. Overflowing drains can cause
for overall system operation.
- Inspect blower assembly operation and lubricate if necessary Motor will last longer.
- Evaluate condition of air filters and other indoor air quality accessories … Dirty air filters can increase
operating costs & may cause furnace to overheat.
- Safety test all controls for proper operation Fan switch checked and adjusted as needed. Combustion air openings
checked. Blocked or restricted combustion air openings can be dangerous. Safety controls that do not operate can
cause dangerous problems.
- Check/Calibrate thermostat and confirm proper operation.
- Evaluate the overall efficiency of the system and inform customer of equipment condition.